A. tension
B. shear
C. compression
D. all of the above
E. none of the above

Advertisement

Related Mcqs:

  1. The shearing stresses in the inner face as compared to outer face of the wire in a heavy close coiled spring is_________________?
    A. larger B. smaller C. equal D. larger/smaller depending on diameter of spring coil E. unpredictable...
  2. Resilience of a material is important, when it is subjected to________________?
    A. combined loading B. fatigue C. thermal stresses D. wear and tear E. shock loading...
  3. Endurance limit or fatigue limit is the maximum stress that a member can withstand for an infinite number of load applications without failure when subjected to________________?
    A. dynamic loading B. static loading C. combined static and dynamic loading D. completely reversed loading E. all of the above...
  4. Spring stiffness is__________________?
    A. ratio of coil diameter to wire diameter B. load required to produce unit deflection C. its capability of storing energy D. its ability to absorb shocks E. none of the above...
  5. If a spring is cut down into two springs, the stiffness of cut springs will be _________________?
    A. half B. same C. double D. unpredictable E. none of the above...
  6. Form coefficient of spring is _____________________?
    A. ratio of coil diameter to wire diameter B. load required to produce unit deflection C. its capability of storing energy D. concerned With strength of wire of spring E. nothing...
  7. Spring index is___________________?
    A. ratio of coil diameter to wire diameter B. load required to produce unit deflection C. its capability of storing energy D. indication of quality of spring E. nothing...
  8. Whether any core is required in wire ropes________________?
    A. yes B. no C. sometimes D. rarely E. very often...
  9. If an unsupported uniform cross sectional elastic bar is subjected to a longitudinal impact from a rigid bob moving with velocity v, then a compressive wave of intensity sc is propagated through the bar as follows______________________?
    A. vpE B. vVvF C. WpE/2 D. IvHpE E. none of the above, where E = modulus of elasticity and p = mass density...
  10. The building up of worn and uridersized parts, subjected to repeated loads by electroplating is_____________________?
    A. best method B. extremely hazardous C. has no effect as regards fatigue strength D. cheapest method E. all of the above...
Advertisement